Worker suffered crushing injuries when steel truss fell on him
AZZ Galvanizing Canada, a company out of Saint John, N.B., has been fined $65,000 in Burlington, Ont. court, along with a 25 per cent victims fine surcharge.
On July 25, 2016, a worker was working as part of a night shift crew galvanizing steel trusses at an industrial establishment in Acton, Ont. Part of the galvanization process includes manual cleaning of the truss for quality control. A forklift is used to move trusses to the shop floor for cleaning. Each steel truss is about 18 metres (60 feet) long and weighs about 453 kilograms (1,000 pounds).
That night, the forklift used to move the trusses was smaller than the forklift normally used, which was in repairs. It was also the first time this smaller forklift had been used to lift a load of trusses of this size and weight. A safety sensor in the operator's seat was not working at the time. In normal operation, when the forklift's operator is not seated, the sensor engages a lock system that does not allow the forklift mast to lift, lower or tilt until the operator returns to the seat.
On the shop floor, the operator left the forklift unattended during the clean-up process. The sensor did not engage the lock system.
To accommodate the cleanup, the forks were raised approximately 0.75 to 0.90 metres (2.5 to 3 feet) above the shop floor. The load of trusses on the forklift was also not braced or restrained from tipping in any way. The worker and a co-worker were cleaning the trusses when one truss tipped from the forks and fell on the worker. The worker suffered crushing injuries.
The defendant, AZZ Galvanizing Canada, failed to ensure that an operator attended a lifting device's controls when its load was in a raised position. This contravened section 51(2)(b)(iii) of Regulation 851 (Industrial Establishments), of section 25(1)(c) of the Occupational Health and Safety Act.
Source: Ontario Ministry of Labour
